Gather any/all buttons that need to be paired, the mobile device, and the charging cradle. The charging cradle will need to be plugged into power.
- Power down the Mobile Guardian.
- Turn the device back on using the power button.
- If the device is powered on by placing it in the charging cradle, the button pairing will notbe successful.
- On the bottom of the cradle, there is a small button to initiate training mode.
- Press and hold until you hear it beep then release. You will need something like a pen in order to press the button.
- The mobile device will then announce, “Device Training Initiated.“
- Press the emergency button on the mobile device once and release it.
- You should hear the announcement “Training Success.“
- Press the emergency button on any pendant you want to train once and release
- You should again hear the announcement “Training Success.“
- Once the training period is over you will hear the announcement “Device Training Completed” and the mobile device will beep once more.
- This should occur after 30 seconds.
- Test the newly paired button