1. Home
  2. Knowledge Base
  3. MGHome Landline- Pairing a button

MGHome Landline- Pairing a button

Getting Started

  1. Take the new button(s) over to the base station
  2. Check to make sure the device is connected and powered on. (The info button light will be green.)

Pairing the Button

  1. Press the white pairing button on the back of the device to initiate the verbal cue “Entering Pairing mode. Press the button on the peripheral to connect to the device.” The info button will flash blue while in pairing mode.
  2. Press the new button for 3 seconds and when the pairing has been completed, the device will state “Pairing Completed. Exiting learning mode”
  3. Test the button to confirm it was paired successfully.
  4. Repeat as needed.