1. Home
  2. Knowledge Base
  3. Active Guardian – Initial Setup and Installation

Active Guardian – Initial Setup and Installation

Follow these steps to install the Active Guardian:

  1. Plug the charging cradle into a power outlet and a red LED light will illuminate on the cradle. (Avoid power strips and outlets controlled by a light switch)

  2. Place the device into the charging cradle. After a few seconds, the device will vibrate and state “charging.”

  3. The lights on the device will illuminate.

  4. A blinking blue LED light means the device is connected to the network.

  5. While charging, the red battery light on the Active Guardian will flash every five (5) seconds. Once your Active Guardian is fully charged, this battery light will be solid red.